Skip to main content
Thank you for your patience as we work through our high volume of requests. If you need assistance with 2FA, please provide the correct phone number in your ticket request so we can assist quicker.
Help Center Community Shop

Breda Accessory ????

jpc
Hello

Not sure what I have here.

The wrench is aluminum with a steel insert. The insert is tapered about two-thirds of the way with fine grooves not threads.

thanks for the help

jpc

0

Comments

4 comments

Date Votes
  • TRAP55
    This is my best guess.
    Breda used choke tubes with internal threads that screwed on over the muzzle instead of into it. The tool for cutting those threads looks just like that. There's a piece that fits into that, that has a pilot shaft to fit the bore, and is surrounded by "fingers" that cut the barrels external threads.
    0
  • jpc
    Thank you for the information and I will check it out ??

    take care

    jpc
    0
  • jpc
    From: Info BREDA
    Sent: Friday, May 31, 2019 3:21 AM
    To: JPC
    Subject: Re: Information Please

    Good morning,
    this is a very old tool used to ?re-balance? the profile of 12gauge shells.
    Hunters were used to reload by themselves ammo and, after the process, the profile of the shell may be not straight. This tool needs to make it straight again after the reloading process.

    PLease consider that many shotshells in Europe were made in carton-paper too? this is why this tool was important.


    Best Regards
    MicheleM | Customer Service
    Info@bredafucili.com
    0
  • TRAP55
    jpc, thanks for the update. Would have never guessed that one.
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?