243 to 6mm rem

Hawkshaw

October 22, 2013 17:49

will a rem 700 bbl thread up to a rem. 600/660 action. Could you then rechamber to 6mm rem.? The action is from a rem 660 6mm. THX

0

• 

  Ray Boone

  October 22, 2013 18:04

  Basically anything can be done, however rechambering the 243Win to the 244/6mm isn't practical- the Win is wider at the shoulder than the Rem so the chamber would need to be cut farther into the barrel, which would have less diameter/strength forward of the chamber where pressure requires it. It would be possible to go with an Improved Rem that had the taper decreased so it would fill the previous chambering.

  0
• 

  MIKE WISKEY

  October 28, 2013 06:27

  THREAD DIMENSIONS ARE THE SAME BUT AS HAS BEEN POINTED OUT THE BARREL WOULD HAVE TO BE SHORTENED (AT THE CHAMBER END) FOR THE 6MM REAMER TO 'CLEAN UP' A .243 CHAMBER.

  0
• 

  SoreShoulder

  October 28, 2013 07:18

  I think the 243 has less body taper than a 6mm. So even though the 6mm is longer, it wouldn't cut away the entire 243 chamber.
  
  In other words, the 243's shoulder is shorter but it is wider than the 6mm case and you would get a double shoulder in your chamber.

  0
• 

  RCrosby

  November 05, 2013 18:25

  Action length might also be a problem.

  0
• 

  kumate

  November 06, 2013 14:38

  you might be able to locate an original 660 barrel in 6mm, although they weren't as popular as the 243. good luck with the project

  0
• 

  OleDuk

  November 26, 2013 15:57

  Sore, Mike, & RayB got it right.
  
  Cheers, OleDuk

  0

Please sign in to leave a comment.