Looking for a reputable gunsmith in Charleston SC
Looking for a reputable gunsmith in Charleston SC to ream and thread a shotgun barrel for choke tubes.
Thanks.
Thanks.
0
-
If you don't find someone, there were places that rented them - not a real hard project. Plus shipping off barrel(s) doesn't take the paperwork as actions/firearms require. 0 -
Check with "COPPER TOP" over on the wanted to buy board...He used to have a gun shop in Charleston.. Hes a really good guy...Tell him JIM STARK sent you.... 0 -
quote:Originally posted by charliemeyer007
If you don't find someone, there were places that rented them - not a real hard project. Plus shipping off barrel(s) doesn't take the paperwork as actions/firearms require.
I didn't know you could rent them, I'll look into that. Thanks.0 -
quote:Originally posted by JIM STARK
Check with "COPPER TOP" over on the wanted to buy board...He used to have a gun shop in Charleston.. Hes a really good guy...Tell him JIM STARK sent you....
Will do. Thanks.0 -
Never rented here but knew folks that did years back.
https://4drentals.com/products/tool-rentals/shotgun-tool-rentals/
When I did my barrels one needed thin wall so I did both as thin wall so I could share 5 tubes between the 2 guns.
If you have a rib leave the barrel stick out under it a little.0 -
You can also send the barrel(s) off to Briley or Carlsons and have them do the installation. 0 -
Thanks everyone. 0 -
Mike Orlen does outstanding work and isn't near as expensive as most others.
Would be best to contact him as the pricing may have gone up some since this was posted.
http://users.dls.net/~rdouglas/MikeOrlen.pdf0 -
quote:Originally posted by asphalt cowboy
Mike Orlen does outstanding work and isn't near as expensive as most others.
Would be best to contact him as the pricing may have gone up some since this was posted.
http://users.dls.net/~rdouglas/MikeOrlen.pdf
I have already reached out to him, thanks.0
Please sign in to leave a comment.
Comments
9 comments