Annealing question

notnow

November 18, 2018 18:16

Where in the sequence of case prep is annealing generally performed? What if I anneal cases that have already been prepped completely? Should I resize and trim or will annealing have that much of an effect on the cases. These are cases I size with a neck sizing die.

0

• 

  rufe-snow

  November 18, 2018 20:09

  Lot of unknown variables? How many times, do you reload each fired case? Have you observed cracks, in the case mouths or necks of the reloaded brass? Do you use brass from different manufacturers, or just one brand?
  
  I wouldn't be doing any annealing. Until you built up a data set, regarding the above points.

  0
• 

  charliemeyer007

  November 19, 2018 00:35

  I generally do it on fired cases before any other steps. I like the dip in the lead pot, then drop the case in water procedure. Having a spent primer in place limits the lead level inside the case.

  0
• 

  mrbruce

  November 19, 2018 03:46

  They need to be annealed before doing any case prep other wise your not taking advantage of the process..

  0
• 

  truthful

  November 19, 2018 13:46

  If you are going to anneal, you could clean the fired cases first, but otherwise don't do anything else prior to annealing. There are several different methods of annealing but whichever method you choose, be sure to anneal only the upper portion of the case. Annealing the primer end of the case can cause blown primers and other indications of excess pressure. Don't get the metal too hot. I used to stand the cases mouth up in a shallow pan of water, play a torch flame on the mouths then tip them over into the water to cool.

  0
• 

  sandwarrior

  November 21, 2018 17:22

  First, I suggest a regular annealing regimen. Too soon or too late in the reloading process doesn't make any difference if you have already started to see some cracks in some of the necks.
  
  If you start now, but think you might see cracks in the near future, anneal before you size. Sizing is the most movement and work hardening of the brass. If you wait until after you size, there is a chance the brass will expand where you don't want it to. The caveat here is Lapua sends you annealed brass (new) and you won't have this issue.
  
  It doesn't hurt anything to anneal correctly. You still have to watch your brass for growth after firing.

  0

Please sign in to leave a comment.