beretta 70 parts

sparkcheck2012

May 16, 2018 04:17

I recently purchased a parts kit, (everything but the frame), for a beretta 70 puma .32acp. the barell will not fit into the frame, too tight, why would this be?

0

• 

  charliemeyer007

  May 16, 2018 05:14

  I'm guessing that it needs fitted, or something is wrong/different.
  
  https://en.wikipedia.org/wiki/Beretta_70

  0
• 

  nmyers

  May 16, 2018 06:43

  If you have a frame made by Beretta, with a Beretta serial number, then Beretta parts in Beretta bubble packs should just drop in, with the possible need for burnishing.
  
  Neal

  0
• 

  rufe-snow

  May 16, 2018 07:30

  Check the frame with magnet. I tried the same thing years back. With a Beretta Model 101. Which I believe is similar to the Model 70. Found out that Beretta used both alloy and steel frames. And there are slight dimensional differences.
  
  Believe that the Model 100, which is a .32, had a steel frame. Whereas the 101 in .22, had a alloy frame. If the 70 your working on, is similar to the 100/101 Models? Might be the crux of the problem?

  0
• 

  sparkcheck2012

  May 17, 2018 04:34

  Thanks for responding, It has an alloy frame.
  I purchased the parts kit simply for spare parts availability, so no loss no foul.
  The model 70 is a nice little gun and a fun shooter.

  0
• 

  kimberkid

  May 25, 2018 16:57

  I've got the model 70 in both 22 & 32 can I take a measurement for you?

  0

Please sign in to leave a comment.