Lee shell holder - RCBS Hand primer tool

94fuelie

December 20, 2009 15:26

Hello Friends,

This is my first post.

I recently purchased an RCBS Rockchucker kit that came with a hand priming tool. I have Lee dies with a Lee shellholder. Do I need to purchase an RCBS shell holder for this hand primer? I am using the hand primer with the large primer fitting (black) but I cannot get it to feed a primer into the tube so that I can press it into place.

Thank you kindly.

0

• 

  Pearyw

  December 21, 2009 03:36

  My RCBS priming tool uses the same shell holder that you use in your loading press. This is different from the Lee shell holders.

  0
• 

  dcs shooters

  December 21, 2009 05:11

  What caliber are you trying to load? If the shell holder is for something that takes a small primer, that's why the large primer won't feed through [;)]

  0
• 

  94fuelie

  December 21, 2009 07:58

  Hello,
  
  Thanks for the replies and questions.
  
  I am intending to load .45 Colt. I used the Lee .45 Colt shellholder to remove the primers on my RCBS press. The primers do not seem to slide all the way into the slot. The rod that pushes them up does not seem to seat all the way down when the primer tool is open. It sticks up about 1/16th inch.
  
  Greg

  0
• 

  dcs shooters

  December 21, 2009 10:26

  You don't have the rod in upside down do you [?] It has a flat end and a round end. Make sure the tool is together right.

  0
• 

  94fuelie

  December 21, 2009 13:03

  I put the rod in flat end up as the instructions state. But it seems to sit a little high. I will check to see that the round end is in the "socket" down below.

  0
• 

  94fuelie

  December 21, 2009 19:33

  I got it working. Thanks for the help!

  0

Please sign in to leave a comment.