Case tumblers
What brand of case tumbler do you own? What brand of case tumbler would you recomend?
0
-
Who makes big case tumblers.Iwould like to do 10 to 15 lbs at atime.Thanks for any info. 0 -
Zip Trim from Lee, and a cheap scrubby sponge. (You will have to get the "Universal Shellholder, unless you wanna buy the trimming accessories for your caliber) 0 -
amonnia and water I believe the same as jewery cleaner. scrub em up.
They won't be polished dull clean look. Polished doesn't help performance any how. After you reload them wipe them down with WD-40 [fish oil] will keep finger prints and oxdizing.0 -
insert case into caseholder for a drill. Spin case while running a rag with brass polish on it,..up and down the case until it shines up. Done in minutes. 0 -
You'll need the Zip Trim anyway, because after about two shots from the same case, it is getting long enough to maybe not allow the bolt to close if you only neck size. That is the way it works for my .308 anyway. 0 -
i'm not a high volume reloader but i still think having a tumbler and using it is a good idea,i like cleaning my brass before running them into a fl die,also cleans inside the neck making extraction from the die easier,just my opinion but i'd recommend getting one 0 -
quote:Originally posted by rotarymetertec
amonnia and water I believe the same as jewery cleaner. scrub em up.
They won't be polished dull clean look. Polished doesn't help performance any how. After you reload them wipe them down with WD-40 [fish oil] will keep finger prints and oxdizing.
Ammonia is not good for Brass. Its been covered on here before. causes it to crack.0 -
2 solutions come to mind for cleaning brass without tumbling.
1- 1 bottle 'no drip' coffee pot cleaner/decalcifier. It's a mild acid- to 1 gallon of water. Rinse the cases in this for a few minutes, agitate, then remove.
2- 2 parts white vinegar to 1 part water, and a few squirts of lemon juice plus a little dish detergent. Same as above, let soak, agitate, remove.
Both of these are mildly acidic. I finish with a bath in baking soda/warm water, then rinse. You can reuse the solutions a lot and the dirt settles to the bottom of the jug. If you are careful you can pour some off to use without disturbing it.
Unless it is really a grungy case I sure don't bother cleaning them by hand.
But you are really just looking for clean brass. Shiny is a secondary concern. Scrubbing them with a toothbrush or whatever would work fine as well. Clean but not shiny.0
Please sign in to leave a comment.
Comments
8 comments