RCBS bullet puller
I have the RCBS inertia, hammer like, bullet puller. I always have made a dummy round to check things out after I measure for gap from the lands. My problem is on the WSM and the WSSM. They don't fit, to fat. Is the there a fix to this or do I need a different puller.
0
-
I undercharged some rounds and I wanted to pull the bullets and correct it. Right now, I only have a kinetic bullet puller. I saw the bullet puller collets at Sportsman's Warehouse but I didn't know if there is more that I need. My dies are RCBS as well. 0 -
You need to buy an RCBS collet bullit puller, part#09440 for the puller, then buy the caliber specific collet for the bullets you are pulling. I paid $10.99 for mine a few years ago, they are higher now. The collets are about 10 bucks each, just ordered one for 45cal. Buy them from Midway, Graf & sons, or go to your local Sportsmans Warehouse. They screw into your press just like your dies, put the loaded case in the shell holder, raise the round up into the collet, tighten the clamp and pull up on the press handle. No muss no fuss and no spilled powder.[:D][:D]
W.D.0 -
+1 on the RCBS collet puller.
It works best on long rifle bullets.0
Please sign in to leave a comment.
Comments
3 comments