Skip to main content
Thank you for your patience as we work through our high volume of requests. If you need assistance with 2FA, please provide the correct phone number in your ticket request so we can assist quicker.
Help Center Community Shop

Reloading manuals

drobs
I'm going to take some sage advice and order two.

I think one will be the Contender Manual. Any suggestions for a second?

Ben

President: Loyal Order of Teletubbies
elefuns5038.gif
Distinguished Kuwaiti Observer
un_medal_ikom.jpg
0

Comments

13 comments

Date Votes
  • drobs
    I need to get one. Which is the best to get?
    0
  • Tailgunner1954
    IMHO, the one put out by the maker(s) of the bullet(s) your using.
    For rifle I like Nosler and Sierra
    0
  • Odawgp
    What Tailgunner Said

    you can also use reloading data from the maker of the powder that you are intend too use.

    I prefer the hodgdon manual. It's 7.99 at the grocery store magazine stand.

    I also have a Nosler,Speer,& Barnes Mannuals
    0
  • bpost
    IMHO; buy them ALL. There is a wealth of information available with some books leaning towards some power types you may not have tested.

    When I run into problems I tend to compare the books to find similarities between reported MV and charge weights. I still use my first reloading books as a reference on what I used to load and the MV of what I am loading now.
    0
  • flyingtorpedo
    You can get a free printed one from IMR here.
    http://www.imrpowder.com/data/index.php
    0
  • BHAVIN
    I have several and for rifle I think Sierra is my favorite. It has a good section taking you through the whole process or reloading, sections on reloading for gas guns and alot more info that most of the others do not have or do not go into the depth that Sierra does. The Sierra pistol info however is not great. I use the Hodgdon annual manual as it has Hodgdon, IMR and Winchester powders in it. It is also about $8.00 so it is one you should get. I probably open my Nosler book the least. The Speer manual isn't bad but they don't have some of the newer powders listed.
    0
  • Pearyw
    Lyman's is the most versital. If you want to use lead bullets, they have the most info. Since they don't make bullets, their info is more broad.
    0
  • JustC
    Nosler and Sierra
    0
  • konamtbiker
    I own Hornady, Nosler, Sierra, Speer, Swift, Barnes, Vhitavouri. The ones i use most and find most helpful are the Nosler, Sierra, and Hornady. All manuals have their pros and cons. I would suggest getting atleast 2 manuals. This way you can compare velocities, Powders, bullet weights, cases, primers form 2 different manufactures. Good luck!!
    0
  • sandwarrior
    drobs,

    I would do like suggested by many above and that is to get several. As many as your budget allows one or two at a time. And don't hesitate to buy old ones.

    One reason I like to buy a few is because I get a lot of reloading information on the internet. I like to cross-reference it against three or four sources. I'm often times interpolating off a slower powder or a heavier or lighter bullet and adjusting from there. With many references you stand a much better chance of getting at least one direct reference to the load you are trying to work up.
    0
  • 5mmgunguy
    If you are just going to buy one I would buy a Speer or a Hornady. Start low on the loads and work your way up but all in all I have found them to be the most realistic.
    0
  • skyfish
    I have a Lyman and Hornady, then I do a lot of cross checking on the interent. I've used Accurate, IMR/Hod/win, and Alliant, all have good sites.
    0
  • ChetStafford
    Buy all you can get your hands on and all you can afford

    I have six and would not be above another[;)]
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?