Birchwood case cleaner?

Mort4570

July 22, 2007 20:13

A friend brought over some brass to load that he'd cleaned with Birchwood Casey Brass Cartridge Cleaner.
He says he followed the directions,but that brass was all but impossilbe to run thru the sizer.
It was 45 colt brass,once fired.
There cases were sticky and gooey,and just plain Fugly.!
should it have worked better than this?
as I recall,he mixed a batch up,let the brass soak for 3 minutes,and dried,per insturcitons.
did he mess up,or is that stuff just plain messy??

0

• 

  788-308

  July 22, 2007 21:46

  IMO, he did not rinse the cases in plain water.

  0
• 

  BHAVIN

  July 22, 2007 21:51

  I agree with 788-308. I think he may have missed the rinse part of the instructions.

  0
• 

  Mort4570

  July 23, 2007 06:30

  that would sure do it.I'll call and see if he did that.
  
  
  otherwise it's prety good stuff?

  0
• 

  RCrosby

  August 10, 2007 02:22

  Otherwise pretty good stuff. I've used it quite a bit after my tumbler died. I prefer a good tumbling, but using the B.C. they do come out looking a lot better than they went in. With the B.C. you just have to make sure to thoroughly rinse and DRY, and with any of the tumbler/vibrators be sure you've gotten rid of all the medium. (Especially in primer pockets and flash holes.)

  0
• 

  jonk

  August 10, 2007 06:19

  It works, but you do have to rinse. I have had just as good of luck with Purple Power; immerse the brass in it, let soak a few minutes, agitate, dump out (save the purple power, you can reuse it a number of times), and rinse in hot water.
  
  Not worth it. If I want them shiny, they go in the tumbler.

  0
• 

  RCrosby

  August 10, 2007 06:22

  Saving the liquid for re-use goes for the other liquid cleaners as well. Good advice.

  0
• 

  JustC

  August 10, 2007 11:20

  boiling water with a touch of vinegar works every time. Agitate, let sit, agitate, let sit, then dump and rinse.

  0

Please sign in to leave a comment.