forster trimmer ?
i have a forster trimmer that i am having prob with.i bought the trimmer and bushings as a set.i have been trying too trim my 22-250 brass but i after i full lenght size it, the number 2 mandrel will not go in the case mouth.i have 2 number 2 mandrels and they are both too big. i even tried just neck sizing some fireformed cases and they are still too big .any help is apprec.thanks
0
-
The .22-250 trim pilot is for .224 diam bullets.
You might try a .22 Hornet trim pilot, for .223 bullets.
Or, go even smaller with a .204 Ruger trim pilot at .204". Not recommended. The experts will jump all over me for that advice.
Both are available from Forster.
Or, chuck the pilot in a lathe and "emery" it down a .001 or two.
Be sure to mark the pilot for your .22-250.
Be sure the brass is square when the collet tightens up.0 -
Mine is stamped with 22 on the end and measures .2200. It works great. What does yours measure? 0 -
I have a forster original case trimmer kit and all of my pilots are stamped .20,.22,.24 and so on and the .22 fits fine in 22/250 or .223
my trimmer is a very nice tool and I am sure you will like yours also0 -
You should trim them before they are sized, and your problem should go away..... 0 -
Ditto to mrbruce, I had the same problem, then started to trim before sizing. That cured the problem. 0
Please sign in to leave a comment.
Comments
5 comments