removing military crimp
What us the best way to remove the primer crimp? Forster makes a crimp remover for my case trimmer does any one have any experience with this tool? or is there another tool that is recommened?
0
-
How do you remove primer crimp in military brass?
dgac0 -
So far I have used a hand reamer for a bit then I decied to speed it up by putting it in a drill. It works ok, but if you plan on doing many I would suggest doing something else. I then steped up to a RCBS Swager for my single stage press. This combo works very well and makes things pretty uniform to work with. Last year I got a RCBS power case trimmer and so I picked up a Prep Center too. I just bought a Military crimp remover for the Prep Center. I have not had a chance to use this one yet. I have about 1000 .223 cases left to do which is not too bad. I have about 6000 .308 that I need to do and that will be the killer part. 0 -
I prefer swaged over reamed. IMO swaging does a better and more uniform job and does not remove to much brass allowing for more loads before scrapping. I have done thousands of 223's on the RCBS swaging tool and a whole lot more on the Dillon super swager. If you are going to do a bunch the Dillon is the way to go. 0 -
I have done thousands of 5.56 and 7.62 with my Dillon swager. It works great and leaves a smooth edge around the pocket to ease the new primer in. 0 -
Another vote for the Dillon swager.
The RCBS tool works well, but for quanity use the Dillon is the way to go.
The only setback is the initial price, but with lots of cases to do it will seem like a bargain by the time you're done.0 -
I found a solution to this problem I ordered 500 rounds of new lapua brass from a friend at his cost no more military brass for me I hate those crimps it sucks removing them 0 -
The Dillon is not cheap but if you buy one, you'll never look back. Its great. 0 -
+1 for the dillon 0
Please sign in to leave a comment.
Comments
8 comments