Anyone have problems....

Cubslover

February 18, 2006 06:31

using federal primers in a Lee setup? Cabelas said that they were not recommended in Lee Reloading setups. I bought Winchester Large pistol primers, only to find out that I need small's. So I returned them with the intentions of getting the same brand. The only small pistol primers he had were Federal's. So I have them now, hoping that they will be ok.

Any help is appreciated,
Thanks

0

• 

  Pearyw

  February 18, 2006 06:42

  There is nothing wrong with Federal primers. They are usually fire with a lighter firing pin strike than CCI or Winchester. They are more likely to go off if you are using the Lee Loader that you seat the primer with a rod and a hammer. I started off with one of those 45 years ago. It will get your attention when one goes off while you are seating it. If you are using a Lee press there is no problem. I find that Federal's are the mosr sensitive, then Winchester, and finally CCI reqires the hardest firing pen strike.

  0
• 

  Warbirds

  February 18, 2006 07:18

  The entire time I've been reloading I've only had one primer go off on the reloading bench, and I wasn't the guy doing the reloading I was just hanging out. If one goes off it will sure get your attention.

  0
• 

  buddyb

  February 18, 2006 17:18

  I think I remember reading Lee does not recommend Federal primers because of the possibility of mass detonation in their priming tool.I would think a hundred primers going off in your hand would ruin your day.

  0
• 

  sandwarrior

  February 18, 2006 17:58

  cubslovers,
  
  Another thing to discipline yourself into doing is pointing the shell case away from you as you press the primer into it. I've caught myself having that pointed at me numerous times only think what would happen if it went off. The flame'spray' if you will comes out like an unchoked shotgun. It leaves a nice wide pattern. with range of a couple feet at least.

  0
• 

  mrbruce

  February 19, 2006 07:36

  Don't worry about using federal primers, just don't be to heavy handed while using the Lee primer tool.
  Keep it pointed in the right direction just in case.
  I use Federal primers about 90% of the time, on all reloads.

  0

Please sign in to leave a comment.