260 problems
I have a Ruger 260 Remington I bought it new and have only shot it maybe 200 times. The main problem is using brass fired in the gun full length resized I get exctaction problems with starting loads. no presure signs just sticky extraction. factory loads extract just fine.
I have been reloading for over ten years and have never had any kind of problem before this
I have been reloading for over ten years and have never had any kind of problem before this
0
-
Is not enuff powder just as bad as too much [?] 0 -
describe your reload - in detail 0 -
The best I can remember it was a remington case new, and 125 grain Nosler partition. I can't remember the powder but it was a starting load out of Noslers reloading book. 0 -
Tough call on so little info. Sticky extraction is a red flag high pressure sign. Stop and check everything = maybe your scale isn't balanced and accurate - test it by weighing a bullet. maybe you got the wrong powder - maybe cases aren't sized correctly -- double check everything - reread the reeloading procedures in the front of your reloading book but figure this out before you do it again. 0
Please sign in to leave a comment.
Comments
4 comments