Bought some surplus powder

jonk

July 28, 2002 08:46

This is going to be my first experience with surplus. I picked up an 8 LB jug of WC852 (I think, I don't have it in front of me) that approximates H414. As H414 is at the top of many load lists in my load book I figured it would be a good start place. One question: The label says it is a little slower than regular H414 but H414 load data should be used, starting with the start load. I'm a little curious about max loads though. If it is a little slower than the civilian powder, would max loads not be a little higher than those listed?

"...hit your enemy in the belly, and kick him when he is down, and boil his prisoners in oil- if you take any- and torture his women and children. Then people will keep clear of you..." -Admiral of the Fleet Lord Fisher, speaking at the Hague Peace Conf

0

• 

  MIKE WISKEY

  July 29, 2002 06:19

  DO LIKE ONE LOCAL RELOADER USED TO DO, KEEP ADDING POWER ONE GRAIN AT A TIME UNTILL THE PRIMERS FALL OUT AND THEN BACK OFF ONE GRAIN....JUST JOKING. A LOT OF THINGS WILL EFFECT THE 'MAX.'LOADING FOR THIS POWDER, THE CAL. CONDITION OF THE BARREL, PRIMER, ECT. START WITH THE RECOMMENDED START LOAD AND SLOWLY WORK UP UNTILL YOU GET PRESSURE SIGNS (HARD BOLT LIFT, FLAT PRIMERS) AND CHECK ACCURACY (PRECISION). THE BEST ACCURACY LOAD USUALY IS AT LESS THAN MAX.

  0
• 

  Shootist3006

  July 29, 2002 07:35

  Here is some better info on WC852 :
  WC852 Original application is U.S. .30 Cal. Ball M2 ammo, restricted for Machine Gun use ONLY. A ball powder which can be loaded using IMR4831 or Hodgdon H450 data. This is new powder.
  $56/8# jug.
  
  WC852f Original application is U.S. .30 Cal. Ball M2 ammo. A ball powder which can be loaded using Hodgdon H380 data. Typical .30 Ball M2 load was 50-52 grains. This is pulldown powder.
  $64/8# jug.
  
  Go to http://www.gibrass.com/index.html for more info.
  
  Quod principi placuit legis habet vigorem.Semper Fidelis

  0

Please sign in to leave a comment.