Steyr GB 9mm need schematic

yotee

June 11, 2002 11:57

A friend of mine took apart his GB STEYR and brought me the parts to reassemble. I found a schematic for this weapon however it only shows the left hand side. I can see how the left spring on the hammer assembly goes but not the right side spring. Does anyone know how it grabs the hammer? and does someone have or know where I can find a schematic out on the web?
Thanks,

Yotee.

Edited by - yotee on 06/11/2002 17:32:33

0

• 

  JudgeColt

  June 12, 2002 06:47

  The left and right hammer springs are mirror images of each other. The straight inner legs apply force to the rear of the "cross" on the hammer. The outer legs apply force to the rear upper lip of the sear. It is difficult to reinstall the sear once the springs are in contact with the hammer "cross" because there is a lot of tension involved.
  
  I know of no sights on the web that show schematics of the GB. You might check the GunSouth web site, but since GS no longer imports Steyr products, I would not expect to find anything there. A schematic will not help accomplishing the difficult task of getting the sear back into place with the tension on it. While I have not tried it, perhaps the sear could be put into place with the outer legs behind it, which would mean no tension, and then use a needle nose pliers to spring the outer leg towards the inside and then forward under the lip.
  
  If my explanation is not sufficient, I can scan the exploded view from my GB manual and e-mail it to you. If you need that done, please contact me at judgecolt45@hotmail.com and I will try to help.

  0
• 

  captkirk3@dslextreme.com

  June 12, 2002 07:10

  If you're an NRA Member...They have the answer for you...Called the Firearms Assembly Book...and its free...
  
  Captain Kirk, Tech Staff

  0

Please sign in to leave a comment.