sks problem
I purchased a 20 round fixed magazine for the Russian SKS and I had lots of trouble with feeding. After looking the magazine over I found the pin was loose and repeended it and it cycled ok. I took it to the range today and I had some stove pipes and some double feeds. Anyone got any ideas were I may adjust this magazine to take care of this problem.
I was using the old steel core ammo and a friend gave some new wolf ammo to try in the rifle same result, one or two jams or double feed per twenty rounds. The rifle had only about 50 round through it prior to this firing.
Thank, you
Emmett
I was using the old steel core ammo and a friend gave some new wolf ammo to try in the rifle same result, one or two jams or double feed per twenty rounds. The rifle had only about 50 round through it prior to this firing.
Thank, you
Emmett
0
-
Have a Yugo SKS that won't cycle. At first it was firing a shot and then stovepiping. I cleaned it real good and now it just fires one shot at a time, no noticeable bolt movement at all.
I believe the gas valve is in the correct position (down) as this allows the gas into the gas tube, thereby causing the action to cycle. I admit I didn't try it with the valve in the up position, but it appears that would block the gas escape hole. I cleaned it well before firing it.
Also, it's very difficult pulling the bolt back by hand after firing.0 -
GET AN AK-47!!!!!!!!! 0 -
Duane did you disengage the gas tube cut-off? This is the little button at the front of the gas tube. This is found only on the Yugo for the purpose of launching grenades. It blocks any of the gases from going anywhere, but down the barrel, not up and back the gas tube to cycle your rifle. 0 -
Take the upper handguard off and see if you have that intermediate operating rod and spring. Clean out the gas port. 0 -
Ditto Hans
NIKLASAL@hotmail.com0 -
While taking the upper handguard off make sure the gas piston is even in there. You can't miss it. If the "Yugo" gas cutoff is properly adjusted, the gas port is open and clean, and the piston and intermediate rod w/ spring are in place, then i just dunno.
1*0 -
I HAD THE GAS TUBE OUT WHERE IS THE CUT OFF BUTTON LOCATED I DID NOT SEE ONE 0
Please sign in to leave a comment.
Comments
7 comments