Iver Johnson Revolver
I have an old Iver Johnson top brake .38 S&W.It belonged to my Grandfather, he was with the Los Angeles Co. Sheriff's Dept. circa 1903. It is missing most of the interior parts. Hammer block safety, springs, etc. I think both the .32 and the 38 S&W were built on the same frame. Are the interior working parts from a .32 interchangable with an .38 S&W.Thanks in advance for your imput.
0
-
I recently was given an old Iver Johnson revolver that belonged to my great grandfather. I believe it is a .38 cal, top break, 5 shot with a safety on the trigger similar to a glock. It has plastic grips with an owl at the top. On the barrel it says Iver Johnsons Arms & Cycle Works Fitchburg Mass, USA followed by several pat. dates. SN which is located on the bottom of the grip is 7366. Any info would be greatly appreciated 0 -
It depends on which model you have.Some 32 came in a small frame and the 38 came in a large frame.Some parts will even interchange between the two frames.Sear spring,firing pin etc. I should have any parts for this gun that you may need.If you decide to repair it send me a list of everything you need. Thanks. 0
Please sign in to leave a comment.
Comments
2 comments