Hawes 357 Western Marshall

rballi

January 28, 2002 11:50

I know, I know, Colt SA copy, cheap, etc....I need a breakdown or schematic of the gun for dissasembly/assembly. Thanks

Comments

6 comments

rballi

January 28, 2002 11:55
yup, West Germany made, sold out of Los Angeles California. The one I picked up has a gap between the trigger group and frame. I might be really, really lucky and it might just need tightening, but I don't have a small enought screw driver on me now at work to try and tighten them. I'm just planning ahead so that when they probably don't tighten up, I can figure out where the misplaced screw or spring, or whatever goes.Roy
0
rballi

January 28, 2002 12:40
Any info on date of mfg? Ther serial number is 12###/3
0
ATF

January 28, 2002 19:31
Previously manufactured by J.P. Sauer & Sohn in Eckemforde,Germany.
ATF[This message has been edited by ATF (edited 01-29-2002).]
0
v35

January 29, 2002 10:20
Good piece. Grip frame screws loosen up from firing. Get a proper fitting screwdriver before you start so you dont bugger up the screws. Takedown is exactly like the SAA Colt. Gun Parts corp has an exploded view and sells parts for this gun.1 take off grips2 remove 2 rear screws by hammer& 1 screw on bottom of grip to remove backstrap3 remove mainspring4 remove triggerguard5 remove 2 fingered flat spring in cutout under the cylinderThe rest should be self evident. If it isn't take it to a gunsmith.
0
rballi

January 29, 2002 10:48
Thanks to all who responded. ALL the screws were loose; all fixed now.Roy
0
bowhunter32

February 05, 2003 21:57
if you need any parts you can find them at gun-parts.com
0

Please sign in to leave a comment.