Skip to main content
Help Center Community Shop

Grendel p10 assembly ???? Help !!!!!

azgunnut2@yahoo.com
We have a grendel p10 .380 auto that some mornon took all apart and we cannot get it back together ? the hammer assembly has a screw in the rear that threads into a threaded tube , these screws hold this thing in the frame , when we assemble it , then take out the screws (to place it into the frame) it comes back apart , dont see any way to make a 'slave' pin ???? any suggestions ?????? ThankS !!!!!!!!!!!!!

Join / Support the NRA
Guns are my friends !!!

Gunsmith / LEO
0

Comments

7 comments

Date Votes
  • gruntled
    If no one comes up with an answer you might try the Kel-Tec web page.
    The Grendel was the predecessor to the Kel-Tec.
    0
  • pact
    I've done it once and it was not easy. Its hard to remember with out the gun in front of me, but I used slave pins to hold the coil spring in place. I will look at a parts diagram to see if I can remember.
    Know this not much help.

    pact
    0
  • azgunnut2@yahoo.com
    O.K. Guys , Thanks , hopefully some-one can help me cure this crazy item..............Thanks !!!!!!!!!!!!

    Join / Support the NRA
    Guns are my friends !!!

    Gunsmith / LEO
    0
  • He Dog
    This may not help at all, but it is all I can offer: I have a P-30 and would be willing to make copies of the diagrams in the manual and send to you. They may be similar or the same, I just don't know.

    My heros have always killed cowboys.
    0
  • azgunnut2@yahoo.com
    O.k. , well i know "what goes were" but the "how to" is the problem ??
    unless the manuel tells how to get it 'back togethr from a fully striped point' then it will not help , so thanks , but Im still at a loss... The "Keltec" suggestion sounds good , but I have already contacted them and they claim NO Strings to grendel at all in any form!!! and I own two Keltecs (and carry on e'off duty' almost daily), yes they resemble these , but......anyhow , hopefully some-one can help.....
    Thanks !!!!!

    Join / Support the NRA
    Guns are my friends !!!

    Gunsmith / LEO
    0
  • gruntled
    I've heard that most people can't get any help from Kel-Tec with their Grendels. I was hopeing you might find a web site of owners that might be of help. The connection between the companies is an old one but the Kel-Tec is derived from the Grendel.
    With a little luck assembly directions for the Kel-Tec MIGHT be close enough to be of help.
    0
  • azgunnut2@yahoo.com
    O.K. , Thanks , I 'll keep on trying ..........

    Join / Support the NRA
    Guns are my friends !!!

    Gunsmith / LEO
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?