Skip to main content
Help Center Community Shop

What type of FAL reciever is this???

Comments

4 comments

  • punchie
    Welcome to the wonderful world of a Franken-FAL. Metric (FAL) reveiver mated to an inch (L1a1) parts kit. Did you notice the gap at the end of the rev'r. At least you got an Imbel instead of a Century or Hesse Recv'r.

    AN ARMED SOCIETY IS A POLITE SOCIETY<P>
    0
  • richbug
    Another note... when century assembled the rifles, they removed the stud which holds the pistol grip in place. You may need a replacement stripped lower for your rifle if you can't figure out another way to attach the grip. Should be inch pattern stocks.

    My border collie is smarter than your honor student.
    0
  • leeblackman
    Thank you gentleman. I'm assuming its gonna be a type 3 then. I think I'm gonna try to completely restock it with TAPCO's new stocks, the M249 type cosmetic and new forend.
    0
  • richbug
    LBMAN, I was doing some mre looking, and found that some of the century FrankenFALS had Indian Pattern Lowers... These were a real ****** item. Metric buttstock, and a inch pattern pistol grip. Just a note, nearly all metric stocks will fit nearly all metric guns regardless of weather type 1 2 or 3. all Imbels I have ever seen or heard of are type 3. Type 3's are blocky looking with few or no curves. Very utilitarian looking. Type 1's are radiused all over, broken edges with a 1/4" or so radius. They also have a box recessed into the side of the mag well. type 2's are somewhere in the middle. The difference in the buttstocks are that the metric has a single narrow tang with one screw behind the pistol grip.

    My border collie is smarter than your honor student.
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?