Skip to main content
Help Center Community Shop

S&W N-Frame Grips

Comments

9 comments

  • rordog
    I like the Deselerator from Pachmeyer, the Houge is OK, but a little squishy. I have found with high recoil revolvers, the palm of my hand is what gets the most punishment. Maybe a good leather glove with double palm would be worth a try.
    0
  • rchawk
    The Pachmeyer grips have done the job for me, with both a Ruger Super Redhawk and my new Super Blackhawk. If it's still a bit much, try a "PAST" brand shooting glove. Built-in recoil absorber in the palm.


    Hawk


    I would rather be tried by 12 than carried by 6!
    0
  • rsnyder55
    Since the grips that come w/ the S&W are about as unergometric as they possibly can be (the grips get larger at the base where your fingers get shorter) a good wood grip may also suit your needs. I have a set of Eagles on my 629 and I don't mind the recoil because the recoil is distributed over my entire hand. I believe it was Hogue that used to make grips from a tracing you sent them for your hand. I try to stay away from rubber grips because if you make a bad grab and need the gun in a hurry, it takes time to adjust your grip vs. a wood grip.

    Just my .02
    0
  • ranger37
    what I found to work well and a lot of my customers have agreed is the combat finger groov grip from pachmayr or Hogue....

    DO RIGHT GUNSMITH, INC.
    0
  • michael minarik
    Lt.smitty, I have a pr of those grip's which rchawk tell's you about for $17.5 includes shipping. torosaucy@cox.net
    0
  • He Dog
    Offers to sell are not allowed on this board. Read the sticky.

    I also like the Pachmayer decelerator grips, and have them on most of my revolvers. Past gloves are also fine, but with the decelerators I don't need them.
    0
  • rwfixem
    Depends on your hand size. I use the smaller service grips on my N frames. I can hold on much better than the large target stocks.
    0
  • mballai
    I am real partial to Hogue Monogrips. If you reload, you can use make up a softer working load or shoot some 44 Spl until you get used to the power and just increase the charge when you are ready.

    Three Precious Metals: Gold, silver and lead
    0
  • maguirre
    The .44 does punish, especially if you like the hotter loads. Like oothers have mentioned, I prefer the Hogue monogrips. I'm partial to wood, and their finger grooves fit perfectly. You might consider .44 Special loads in your S&W if you just like to target shoot. If you hunt with it, then mag is the way to go, but for targer practice, I get a lot of enjoyment from Special loads. Also, you might consider porting the gun, that helps some folks.

    Strength and honor!
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?