Skip to main content
Help Center Community Shop

+P+ 9mm. Ammo in Glock/Browning HP

Comments

10 comments

  • kingjoey
    I would use it in the Glock but not the HP. I don't recall the HP being +P+ approved. 9mm +P+ rounds are usually for SMG's. .02 [;)]
    0
  • Nighthawk
    I agree with Kingjoey advice on this one.



    Best!!

    Rugster


    Toujours Pret
    0
  • leeblackman
    If u do decide to use +P+ in the browning, then I'd maybe opt to install a stonger reciol spring.
    0
  • RSLINTII
    Thanks for the advice. Any one use +P+ (1350 fps)[:D]? Any other calibers? Best, Robert

    "Endurance"
    0
  • kingjoey
    Use +P ammo occasionally, but as I said earlier, I'd leave the +P+ for the subguns. The high pressure is really tough on the locking mechanisms in a pistol and tend to lead to very premature wear.
    0
  • Rafter-S
    I have found standard pressure ammo gives much better accuracy than +P or +P+. In my opinion, quickness in getting the first round off and bullet placement is more important than velocity.

    Rafter-S

    "What is truth? No wonder jesting Pilate turned away. The truth, it has a thousand faces -- show only one of them, and the whole truth flies away! But how to show the whole? That is the question."
    --Thomas Wolfe, "You Can't Go Home Again" (1934)
    0
  • dennisw
    In the early seventies I fired several cans of surplus mg ammo through
    a 1935 vindage browning, after a couple of cans I replaced the spring
    with a heavy recoil spring. All that was shot for practice. The gun
    showed no damage. I would not shoot a single round of that ammo through a glock.
    dennisw
    0
  • royc38
    i have to agree with dennis. I don't think you should shoot +p in a Glock.
    0
  • RSLINTII
    Bet it would be Great in a Camp 9mm Carbine! Same velosity as a .357 Sig. Probably best to use this stuff in speciality cases (heavy clothing/protection). Why would it say "not for law enforcement use"? Best, Robert

    "Endurance"
    0
  • gunnut505
    Wouldn't own a Glock, know for a fact they have unsupported area around case head in .40-if same area exists in 9mm; DO NOT use other than 9mm para.-you can check by removing the barrel and placing a cartridge into chamber of barrel: can you see the area ahead of the rim?

    If you know it all; you must have been listening.WEAR EAR PROTECTION!
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?