Rem. Sportsman

Vonflak

November 20, 2004 23:17

Hi ya,

I've got a Rem. Mod 11 (sportsman) that needs a scrubbin.

How is the bolt removed?

Thanks in advance

Jesus: Don't leave earth without him

byf'er

0

• 

  Jody Commander

  November 21, 2004 04:33

  Look at the ejection port, there is a half round cut in the bottom edge, now look at the bolt, you will see a pin on the same level as the cut in the ejection port, line them up and insert a punch thru the hole on the opposite side of the receiver, tap out the pin, be sure and align the pin and the cut, otherwise the pin will not exit the bolt and if forced... will damage the receiver.

  0
• 

  CountryGunsmith

  November 21, 2004 04:42

  Pretty much requires complete disassembly of the receiver.
  
  Remove the barrel, forend, recoil spring and buttstock. Drift out the pin holding the action spring and remove it toward the rear. Remove the screws holding the trigger guard assembly and remove it. Dont lose any of the lockscrews. Remove the carrier screws and the carrier. You'll need to remove the carrier spring if it was not mounted in the trigger plate. Swing the link at the rear of the bolt downward and line up the locking block latch pin in the bolt with the half-moon shaped cutout in the bottom edge of the ejection port. Use a punch of the proper size through the hole in the left side of the gun to push the pin out, which frees the locking block latch and spring to be removed from the bottom of the bolt. With the link down, bring the bolt all the way to the rear, hold the operating handle there, and push the bolt forward using the link. The bolt can now be removed toward the front.
  
  Have fun!
  
  
  Scrappy Doo sleeps with the fishes.

  0
• 

  Vonflak

  November 21, 2004 06:30

  Thanky!
  
  Jesus: Don't leave earth without him
  
  byf'er

  0

Please sign in to leave a comment.