ar15 problems
I just built another ar15, and I went all out on this one. It's a colt upper receiver, 20" bushmaster fluted barrel, DPMS lower receiver and lower parts and a colt bolt.
I had the upper put together professionally by a gunsmith.
But the the gun wont feed properly. It doesnt double feed or anything, just sometimes it wont even eject the shell. Sometimes it ejects the shell, bu doesn't load a new bullet. I have to pull back the charging handle after every shot.
The inside is brand new and squeaky clean. I'm shooting winchester ammo and using thermold and colt mags.
Anybody have any tips or advice they'd like to throw my way? Thanks a lot.
I had the upper put together professionally by a gunsmith.
But the the gun wont feed properly. It doesnt double feed or anything, just sometimes it wont even eject the shell. Sometimes it ejects the shell, bu doesn't load a new bullet. I have to pull back the charging handle after every shot.
The inside is brand new and squeaky clean. I'm shooting winchester ammo and using thermold and colt mags.
Anybody have any tips or advice they'd like to throw my way? Thanks a lot.
0
-
go to www.ar15.com and post this issue, they have ALL the answers regarding ar -15's.
muss0 -
check seating on gas tube. even a small crimp can give you a problem. 0 -
Your gas key may be leaking where it mates to the bolt carrier. Make sure the gaps on the gas rings are 120 degrees away from one another.
mag0
Please sign in to leave a comment.
Comments
3 comments