what is the differance in weaver mounts and

Jimmy Boss

October 30, 2004 14:25

Picatinny mounts. Can you interchange them? Thanks

JBoss......Fear No Fish

0

• 

  BigBarn

  October 30, 2004 14:42

  Interchange them with what?????
  
  "Respect the land, and it will respect you"

  0
• 

  tapwater

  October 30, 2004 18:19

  I believe rings/mounts are interchangeable. How do they differ? I don't know either and don't feel foolish asking. Anyone?
  
  The early bird gets the worm, but the second mouse gets the cheese.

  0
• 

  Jimmy Boss

  October 30, 2004 19:05

  Well I was asking if a weaver would fit on a picatinny and would a picatinny fit a weaver type mounting system. Thanks
  
  JBoss......Fear No Fish

  0
• 

  HeavyBarrel

  October 30, 2004 19:21

  I used Leupold PRW {permanent weaver type} rings on a picatinny heavy duty steel mount, the rings did not fit as well as I would have liked. I purchased some heavy duty steel rings designed for picatinny mounts and those fit much better.

  0
• 

  nononsense

  October 30, 2004 21:51

  Accessories fitted for Picatinny rails are interchangeable between other Picatinny rails. The military has seen to this when they issued the MIL-STD 1913 and the addendum Revision "A". This is the standardization required for sharing accessories in the Picatinny system. The slots in the Weaver rails are not equally spaced on the standard Weaver rails unless they are made to mimic the Picatinny specs.
  
  Here are the specifications for the Picatinny Rail System:
  
  
  
  By way of comparison, a couple of sets of Weavers that I have, the slots measure 0.150" wide x 0.100" deep, measured like the Picatinny and have flat bottom slots. Another set of Weavers have a full radius in the bottom of the slots. The full width of the Weaver rail measures the same as the Picatinny, 0.835" point to point.
  
  
  
  
  
  http://www.biggerhammer.net/picatinny/
  
  The link has the PFD files of the MIL-STD 1913 document.

  0

Please sign in to leave a comment.