Skip to main content
Help Center Community Shop

winchester model 59 pigeon grade question

Comments

6 comments

  • only winchesters
    Bobski: My book shows the Md 59 Pigeon as only being offered in 62 and 63, the bolt and carrier should be jeweled, (engine turned). As with all Winchester Pigeons, the interals are all honed. They stamped all other Pigeons, Md 12, 42, 50, 50 Featherweight, and 21, I find it hard to believe they wouldn't do it to the 59. My book shows a couple of Pigeon 59s, neither have a Pad. It did say the Pigeon guns were special order, they didn't make them up in advance. Which seems right, since stock length, engraving, (was an extra) recoil pad or butt plate. You could get standard Pigeon wood checkering or "A" or "B" carved wood, (simalar to the Md 12). Hope this helps you. Regards Dave
    0
  • bobski
    bolt and carrier are turned. all hand honed too. does your pic show the words pigeon? does the stock have a pg cap?
    0
  • only winchesters
    Bob: My book only shows the side view. Yes the standard Pigeon wood, (like the Md 50) with a capped pistol grip. Forearm has the 3 diamonds on the bottom as well as the side pannels. If it's been honed at the factory, they did that before anodisizing the receiver. If the honing took place after it left the factory the anodize would have veen removed. Dave
    0
  • jbc
    I have a M 59 and I'm curious to know exactly how to tell if it's pigeon grade. There is a stamp of some kind on the botton just in front of where the shells are loaded. It's a little smaller than the size of a pencil eraser and it's a circle with a P above a W inside it. That may just be a generic Winchester stamp but just curious.

    Not being a gun expert, I didn't follow the other things to look for that were mentioned in the last post. If there is a way to make that something a novice could follow, I'd really appreciate the help.
    0
  • bobski
    the word 'pigeon' would be right under the serial number.
    0
  • Winchester 1912
    quote:Originally posted by jbc
    I have a M 59 and I'm curious to know exactly how to tell if it's pigeon grade. There is a stamp of some kind on the botton just in front of where the shells are loaded. It's a little smaller than the size of a pencil eraser and it's a circle with a P above a W inside it. That may just be a generic Winchester stamp but just curious.

    Not being a gun expert, I didn't follow the other things to look for that were mentioned in the last post. If there is a way to make that something a novice could follow, I'd really appreciate the help.

    The "WP" in the circle was Winchester's proof mark. This meant that the gun was factory tested with hot loads and withstood the high pressures of firing these "proof" loads thus qualifing the firearm as safe to leave the factory.
    0

Please sign in to leave a comment.

Recent Activity