Winchester mdl 67 help again, please
Hello Ya'll
I bought a new sear, extractor from gun parts. I have installed it with the spring. I can now install the bolt and remove it by pulling the trigger. Where as befor I coulden't. But now when i pull the knob back to cock it, It will not cock. What am i doing wrong. Thankyou beltfed.
I bought a new sear, extractor from gun parts. I have installed it with the spring. I can now install the bolt and remove it by pulling the trigger. Where as befor I coulden't. But now when i pull the knob back to cock it, It will not cock. What am i doing wrong. Thankyou beltfed.
0
-
check the bottom of the firing pin (remove the bolt, you can see the bottom of the f.p.) make sure the surface that engages the sear is sharp and 90 deg., also make sure that the sear is seating in the receiver properly (it sounds like it is as you are able to remove the bolt). 0
Please sign in to leave a comment.
Comments
1 comment