llama minmax .40 s&w

slugo

May 01, 2004 10:16

I am afraid i was foolish enough to buy one of these.Is there a cure for the grooves and ridges in the lock-up wearing. the mating surfaces in the slide have been worn down and the surfaces on the top of the barrel have been hamered to the point that it is hard to take the gun out of lock-up (empty and clean and well oiled , almost impossible to pull back the slide). are there any warranty experiences and or suggestions? Purchased new from dealer. thanks

0

• 

  jsergovic

  May 01, 2004 22:49

  If you are the original owner, sounds like you are dure for a free slide and barrel, installed.
  
  Upon the expiration of the one-year Warranty, and for as long as this LLAMA firearm is owned by the original purchaser, LLAMA offers to service and repair any defects or malfunction in this LLAMA firearm excluding the finish, grips, sights or magazine, without charge. Requests for service should be submitted in writing together with proof of purchase and the firearm (insurance and shipment prepaid by the purchaser) to an authorized service center identified on the enclosed list. Return shipment and insurance shall be paid by LLAMA provided the service is covered by this service contract.
  
  Here's a link: http://www.bersa-llama.com/llama_about.html

  0

Please sign in to leave a comment.