Help reinstalling sear,Ruger MK1/MK2

phxtravis

February 16, 2004 16:23

I made the mistake of removing the sear in an MK1/MK2 and I cant figure how it goes back, I also cant figure how the hammer sits nor the hammer strut.[:(!][?]
Desert Eagle .50AE
Spring 1911-A1 Mil-Spec
Cav Arms CAV-15 MKII(AR-15)
Marlin/Glenfield Mod 60
Mosin-Nagant M38

0

• 

  Hangfire

  February 16, 2004 16:32

  This should do it for ya-
  
  http://www.stevespages.com/page7b.htm
  
  Love them Pre-64's!!!!-Bob

  0
• 

  260

  February 16, 2004 16:35

  remove the magazine. make sure it is not a round in the chamber. dry fire. take a paper clip and pull down on the latch on the rear of the grip frame. remove this latch. now turn it muzzle up. the bolt should come out. if not, give it a wrap at the muzzle end with a RUBBER mallet. it will release now. next , take the mallet and wrap the receiver from the bolt end. the barrel will now come off.

  0
• 

  phxtravis

  February 16, 2004 16:55

  thanks, now I need help replacing the sear, and I cant figure out whichway the hammer and hammer strut goes[?]
  
  Desert Eagle .50AE
  Spring 1911-A1 Mil-Spec
  Cav Arms CAV-15 MKII(AR-15)
  Marlin/Glenfield Mod 60
  Mosin-Nagant M38
  

  0
• 

  260

  February 17, 2004 01:13

  wish i was there to do it for yah

  0
• 

  phxtravis

  February 17, 2004 03:30

  a couple hours of tinkering and a few photos and I finally go it.
  
  Desert Eagle .50AE
  Spring 1911-A1 Mil-Spec
  Cav Arms CAV-15 MKII(AR-15)
  Marlin/Glenfield Mod 60
  Mosin-Nagant M38
  

  0

Please sign in to leave a comment.