Skip to main content
Help Center Community Shop

200gr. JHP .40S&W

jbw1776
Do they make this size for reloading? Who? If anyones ever used this, whats your opinion of it for a personal protection round. Right now I'm using Corbon 150gr JHP, but have been researching, and keep seeing the old arguments about heavier is better for PP stopping power. Thanks,

Ben

James Willis
0

Comments

10 comments

Date Votes
  • Spaz
    I have never seen a 40 S&W round heavier than 180gr.

    I, personally, would stagger the clip.. One round of a hot 180gr, and one round of a air splitting 135gr.. One after another. This would continue until the clip is full..

    You would get the benefits of both a light 45acp and a moderate 357mag. Best of both, frequently argued, worlds.

    Look into http://www.buffalobore.com/, they have a Smoking 180gr shell for the 40 S&W.

    "A clean gun is a happy gun". Spazzzz
    0
  • richbug
    I load 200's in 40 cal for my para ordnance p-16. It is of a design that allows a longer OAL than most 40's(1.26"). With standard data in a 40 you are pretty much limited to 180's. the limited powder capacity of the 40 keeps you in the 180-165 range. If you want to shoot 200's get a 10mm.

    .
    0
  • jbw1776
    In factory loads 180gr is the biggest I've found. But they do make 200gr bullets for reloads, just cant find one in JHP.

    Ben

    James Willis
    0
  • JAK71454
    I think 200gr is too heavy. There may be some bullets avialable but they might be for the 10mm. If they did work they would be going to slow to mushroom. Jim

    Jim Kammerer
    0
  • jbw1776
    Richbug, this is where I was getting my info on the 200gr. JHP for the .40S&W
    since I dont know how to post it here I'll just write it :
    www.angelfire.com/art/enchanter/40.html
    Titled: Improving the .40 S&W

    James Willis
    0
  • JAK71454
    James, The article is very good and makes good points. But most people still go with the light bullet and high velocity formula. Jim

    Jim Kammerer
    0
  • dakotashooter2
    Years back I recall some warnings about loading 200 gr bullets in .40 S&W cases. I believe the combo of small case capacity, long bullet and pushing said load to it's extreme limit led to high pressures. Being many of the guns for the .40 already have some problems with varying degrees of unsupported cases the warning may be valid. Apparently slow and heavy in this cartridge was not accepable to shooters. I believe the 200 gr was designed for the 10mm and it's greater case capacity.
    0
  • jbw1776
    Thanks for all the input, I think you are right, I'd be asking for trouble with a 200gr. But thats what this forums for, to ask the ones that know, so we dont have to learn the hard way. Well since I have a couple of posts left before getting locked, 150 or 180gr jhp? and whats the most potent factory or reload round ya'll like? Thanks,



    James Willis
    0
  • Hunter375
    The 135 and 155 gr. pills were designed for .40 S&W velocities. You can use heavier bullets, but may not get reliable performance since they were disigned for the much higher velocities of the 10mm. 200 gr. is just too big for .40 (the slugs are almost as long as the case). You would be hard pressed to hit 1000 FPS. Even with the 180 gr., the .40 maxes at about 1100 FPS- pretty dismal when one considers the 10mm can achieve 1400 FPS with the same pill. Stick with the lighter slugs that were designed for the cartridge and you will get very satisfactory performance. My .40's have performed very well with Sierra 135 gr. JHP's.

    Save the seals-club a liberal instead.
    0
  • Cubslover
    I "carry" 155gr Winchester Silvertipped hollow's in my 40P and shoot around with any cheap well known FMJ, usually Remington. I've gone through the "Shooters' Bible" and compared the energy numbers from each manufacturer and each type of round. It will tell you what velocity, energy and some other ballistic information for any round (HP, HPBT, FMJ, SP, etc. in any grain) produced by any manufacturer in almost any rifle or pistol caliber. I suggest shelling out $20-$25 at your local gun shop for the same book. Also I heard (by talk not alot of research) that Corbon ammo is unequaled when it comes to stopping power. I believe "Handgunner" magazine rated the Winchester Silvertipped HP's best out of 6 or 7 different brands including CCI/Speer, Hydrashocks(I rate second), and others.



    CZ - 40P 40S&W
    Browning - Hi Power 9mm
    Browning - BuckMark Target
    Marlin - Model 60 .22lr
    CVA - Buckhorn .50cal
    JC Higgins - bolt action 16ga
    Savage - .22lr/.410ga over/under
    0

Please sign in to leave a comment.

Recent Activity