Williams Fire sights
I installed a set, ( front and rear ), of Williams Fire Sights. Its been like five or six months ago. I finally got my single six dialed in using the Williams Fire Sights. I was cleaning the pistol today after going to the range. My guess is that Hops #9 ate right thru the front sight.I'm talking about the little red plastic or fiber thats installed by the factory into the front sight. Has this happened to anyone else?
Psalm 109:8
Psalm 109:8
0
-
I don't know about the Williams themselves, but I can tell you about other fiber optic sights, yes any cleaner does make the brittle, I use the hi-viz, and remove them before each cleaning 0 -
1911a1fan
I've used Breakclean until today.I got a wild hair to really clean the barrell up good. I had the single six pointed down when I gave a few squirks of Hops #9 down the barrel,( using an eyedropper ). I must of turned that gun just right and the Hops went to work on the plastic. I hope I can get some inserts from Williams. I got the toll free number off thier web site.
Psalm 109:80 -
Any solvent will do it not just hops, I have never heard of it happening in one day, it may have been already broke down a bit and the #9 finished it off, I don't know
I do like the hi-viz, while they do not look as good as some, they offer pre cut rods that insert to a notch, and are all of a specific diameter, unlike some that ou have to buy a rod of the stuff, and cut it then burn it to seal it in the site holder, I also love the idea of tru-glows tritium fiber optic sights, but for that reason I will not spend a hundred bucks for them, nor are the rear ones adjustable0 -
Well at least I know how to remove whats left of the front sight. Go figure.[B)][B)][B)]
Psalm 109:80 -
Victor,when you said you used "Breakclean" did you mean Breakfree or Brake-Kleen?"[:)] 


0 -
Oops I sure screwed that up. Yes I did mean Breakfree.Sorry.
Psalm 109:80 -
I called the toll free number today. I'm surpprised, thier sending me free replacement parts.Now how am I supposed to clean the inside of the barrel ,without getting solvent on the front sight? Rubber electrial tape comes to mind.
Psalm 109:80
Please sign in to leave a comment.
Comments
7 comments