Installing a 1911A1 magazine spring and follower

p0838

January 29, 2005 16:08

There are four different ways to install the .45mag spring in to the mag body.
Is there a correct method?

Comments

1 comment

perry shooter

January 29, 2005 17:30
Hello Do you have a magazine with a removeable bottom? if so then just remove bottom install follower and then the spting with the high end of the last coil toward the front If you have a solid bottom mag then take a pencil or other rod and push the follower down until the follower is just above the bottom hole in side of mag slide a pin or small nail thru the hole and this will hold the spring let go of pencil this will free up the follower just shake out follower and then carefully remove pin this will let spring come out . reverse the order to replace with new parts."PRAISE THE HARDBALL GUN"
0

Please sign in to leave a comment.