Skip to main content
Help Center Community Shop

NFA question:part 2

the_punisher_
Hello,I asked a question regarding building a short barreled shotgun and got some well needed answers,but I am concerned about the sawing the barrels part.Would this be something I could do myself once I get the tax stamp or would I need to find a qualified gunsmith to do the work ? Thanks
0

Comments

5 comments

Date Votes
  • 11b6r
    Measure, mark, use a padded vise, and a high quality FINE toothed hacksaw with a tight blade. A guide to keep you square will not hurt. You can use a fine cut file to true up minor imperfections after cut. You can also GENTLY bevel barrel ends, inside/out by hand. Avoid power tools unless you have some background as a machinist. Much easier to remove metal than to replace it. But DO get all paperwork squared away and in your sweaty little hand before you even buy a hacksaw blade. To do otherwise will just ruin your whole day.
    0
  • the_punisher_
    So I would not have to find a class 2 manufacturer or gunsmith to do the work as I could do it myself and save some money.Thanks.
    0
  • 11b6r
    Dude- put this in perspective: You are going to pay the BATFE $200. Your STATE may have a licensing requirement that you are going to pay (if they don't prohibit it entirely) You are going to drive around getting approval from your local police chief, getting fingerprinted, etc etc etc.

    When all is said and done, a good smith would probably cut and bevel your barrel for around $50 or less. That's what you are gonna save. Me, if I really lusted after a SBS, would get the paperwork, find a competent smith (who probably has $200,000+ invested in metal working machinery) and give him the $50. Your mileage may vary.
    0
  • Nwcid
    If you are doing a Form 1 you have 2 choices. Do it yourself or have any gunsmith do it for you. If you want to do it yourself to save money, as 11 said it does not make much sense. If you are doing it yourself cause you want to try it and play go for it.

    If you are wanting a gunsmith to do all the work in the first place why not buy one already built and transfer it on a Form 4?
    0
  • the_punisher_
    Thanks for the advice and after reviewing my options I may just find a qualified gunsmith to do the work.I will call around and see what the gunsmiths in my area would charge to cut down the barrels,after I get the ATF/NFA paperwork in my hands.I will try and keep my eye open for some already made guns,since that may just be the cheaper route to take.Thanks again for the advice.
    0

Please sign in to leave a comment.

Recent Activity