Saiga 308 Batfe Compliance Conversion
I am hoping one of you fellas can tell me if theres a way to meet the five parts(i hope im correct on that number) that have to be replaced with US made parts...without drilling the snot out of my reciever. Like swapping out the piston is one, I got that...
US made trigger assemblies that simply swap out?... that would probably be three...i got the tapco pistol grip AR style 6 position stock... but aint too sure if that will count as one of the 'Five'(again, not sure on that number), or not... I also got the trirail fore arm, for grip, and side mounted weaver scope rail.
I put a post up for advice on a flash suppressor... but no replya s of yet. would a US made Flash Suppressor addition(as the rifle does not have one) caount as one of the 'Five'? a little advice would be great. thank you.
US made trigger assemblies that simply swap out?... that would probably be three...i got the tapco pistol grip AR style 6 position stock... but aint too sure if that will count as one of the 'Five'(again, not sure on that number), or not... I also got the trirail fore arm, for grip, and side mounted weaver scope rail.
I put a post up for advice on a flash suppressor... but no replya s of yet. would a US made Flash Suppressor addition(as the rifle does not have one) caount as one of the 'Five'? a little advice would be great. thank you.
0
-
I hate to send you off this site for answers but in this case going right to the "source" is best. Check out http://forum.saiga-12.com/index.php? as they have step by step instructions for fixing up the Saigas and keeping things legal. 0 -
ok... read that very helpful link to Compliance...
looks like i need to locate some US made parts. Specifically US Made trigger, Hammer and Disconnector... and then i'll have it.
Anyone have Lead on where/who i can find us made replacement parts that dont require drilling?0
Please sign in to leave a comment.
Comments
2 comments