Skip to main content
Help Center Community Shop

Mosin Nagant stock

brunette63
My mosin nagant handgrip likes to slide every three shots. The rings keep sliding. Is their anyway to fix this or is it normal?
0

Comments

7 comments

Date Votes
  • brunette63
    my mosin stock says PU near butt plate does any1 know what this means?
    0
  • armilite
    Don't know if that's normal, but make sure the rings are tight. If not you can take some electrical tape or small piece of fabric or if you've got some double sided tape about 1/4 inch wide and place between the rings and the stock. You can fold them so they don't show and then re-tighten the rings and this should tighten up the stock so it doesn't slide.
    0
  • 1KYDSTR
    I've done similar things to what was just reccomended to you, but I use chip board and cut it to size. No adhesive to gum things up, and it is pretty hard for cardboard so will last a while. One of my SVT-40's loses the front heat shield after about 20 rounds otherwise.
    0
  • brunette63
    how do you tightin rings cuz there is a little space betwwen them but i dont want to not be able to take them off
    0
  • TRAP55
    Most times the band spring isn't doing it's job because it's either gummed up, or needs to be bent a little to hold things in place.
    Take the band off and see if the spring has free movement, and if it sticks out past the wood. Be careful bending the spring, too much and they snap.
    0
  • jonk
    From your description I bet it is a 91, not a 91/30, hence no bandsprings.

    I jammed a toothpick under mine.
    0
  • utbrowningman
    Check at www.7.62x54r.net and see if they have an answer.
    0

Please sign in to leave a comment.

Recent Activity