Remington Rolling Block #4 Solid Frame

Jeepflexin

December 08, 2010 04:08

I recently acquired a nice little #4 whose breach block "flops" when the hammer is pulled back, it seems to be missing a spring. Being the small solid frame model it seems to take a different spring configuration then the larger rolling block actions. I'm hoping some one has a picture of what I need, or just a picture of a good one installed (should be viewable with the fore end removed). So I can as closely as possible replicate it.

I figure it is some sort of flat or V spring (based on the vintage) but I can't figure out how to fit it, it seems like a coil spring set into the fore end would do the job well but I'd rather not devalue the rifle.

Thanks in advance.

0

• 

  JohnnyBGood

  December 08, 2010 04:32

  This is from Remington's 1899 catalog.
  Sorry if the photos are too large but
  I want to try and show you the detail.
  
  I would guess that you need the
  Trigger, Block and Extractor Spring.
  And you're in luck, it's only .25 cents! [:)]
  
  Johnny
  
  
  
  
  
  

  0
• 

  Jeepflexin

  December 08, 2010 05:23

  Thanks guys, it all makes sense now. Looks like an easy fix for a change, I'll order the spring up from the folks listed above.

  0
• 

  TRAP55

  December 08, 2010 12:45

  http://www.gunpartscorp.com/catalog/Products.aspx?catid=11861

  0

Please sign in to leave a comment.