Skip to main content
Thank you for your patience as we work through our high volume of requests. If you need assistance with 2FA, please provide the correct phone number in your ticket request so we can assist quicker.
Help Center Community Shop

Lyman DPS

bperdue21
I have had my Lyman since 2005 and it has worked well since I have had it. I have just started noticing the last few times I have used it, that the powder is starting to stick inside of it. Has anyone else had this problem with it and how have you solved it?
0

Comments

4 comments

Date Votes
  • dcs shooters
    Try washing everything in hot soapy water. And let dry very good.
    0
  • perry shooter
    anti static clothes drier sheets
    0
  • Rocky Raab
    Not sure what you mean by "stick inside it." If you mean that some powder kernels cling to the plastic tube, then it's a static electricity issue (quite common). Tuck a used dryer softener sheet in the tube for an hour or so and that should fix things. (NOT a new one - they are too moist.)

    If you mean that powder is jamming in the feed tubes, that can be due to oily contamination, or simply powder kernels small enough to wedge in - usually very fine sphericals. If the latter, it can take a disassembly and blowout with dry compressed air to get it cleaned out.

    NEVER wash a powder measure. NEVER oil one, either. Once it is clean and unjammed, run a pound of a graphited powder (any of the IMR numbers) through it. That's all the lube you need.
    0
  • bperdue21
    it is sticking to the plastic part the tube sits in, not the tube or the base that the trickler goes through. the paint seems to be starting to come off of it. the worst was getting power pistol powder to come off of it. edit- the part is called the reservoir base.
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?