Question about S&W revolver
I was wondering what model this is. I know it is a K frame round butt. I was also wondering if any K frame hammer will work in this. Thanks, Jeff.
0
-
Serial number? 0 -
Serial # 605067 0 -
Swing the cylinder open the model should be stamped just above the hinge...
Any K frame hammer will fit it if it is a K frame......0 -
You could probably sell the piece easily and buy one with a hammer. It might be cheaper in the long run. 0 -
Looks like a 'pre model 10' k frame ??? not all K frame hammers will work ???
Thanks !!!
d.a.stearns.................a.k.a............SKEEZIX
Gunsmith / LEO
Athens , Tn
www.allamericangunshop.com0 -
Your gun's seen a little "wear".
The model number should be inscribed inside the frame under the barrel when you open up the cylinder. If this is really a K-frame, then a model 10 would be most likely.
As mentioned, any K-frame hammer ought to fit, though whether or not its cost-effective to actually install one is a whole other issue.
You have to figure a decent shape hammer will run maybe $30-40 and then installing it will probably cost that much again (if not more).
Unfortunately, the finish on your gun appears so worn, that the gun itself is probably only worth $200 (or less).
As mentioned, it may just be more cost-effective to swap the entire gun for one you like rather than mess with the hammer.0 -
Prior to 1958 S&W did not have model numbers stamped inside the crane--with that serial number it should be a M&P Model --I just saw some exactly like yours on a S&W forum from the mid 1950's-with that style of front sight--but they had two different hammers--some had that "fishhook" upswept one and others had the standard hammer. Saxon Pig(Doc) has two of them with the upswept fishhook style and 2" barrel and the half moon front sight. 0 -
Yep, it's a M&P Model of 1905, 4th change. With replacement grips.
Neal0 -
Pre-war Smith. Needs a pre-war hammer.
No model number nowhere on it.0 -
The pistol with the bobbed hammer is very usable for it's intended purpose, as a self defense handgun. I can't imagine any need for using it single action. The qualification course for the law enforcement agency I worked for was 50 shots. All fired double action. With a little training a person can hit very well shooting a revolver double action. 0 -
Oklahoma223,
Your gun is a named model "38 Military & police Model of 1905 - 4th Change"
You are correct, it is a 'K' frame. Your gun was manufactured approx. late 1930's. The 'K' frame guns were modified to include an improved hammer block safety in 1944, so you will need a pre-1944 hammer for your gun.
The pre war 'K' frame guns had 3 basic style hammers, they were:
center fire, standard (of which is correct for your gun)
center fire, target
rim fire
Be aware, the internal parts are like a set, & often require fitting so the work together properly. I highly reccomend contacting Smith & Wesson if you are seriously considering any changes. Ask them about the "hammer block safety" upgrade while you are at it.
It's a serious safety improvement!
Jim0
Please sign in to leave a comment.
Comments
11 comments