CZ 75B Omega Trigger Problems
I'm having problems with my CZ 75B Omega. Today at the range it would fire normal leaving the hammer back and the trigger was forward but something inside didn't reset and nothing happened when I pulled it. It was weak all the way back. I removed the magazine and cleared the gun and attempted to dry fire and manually operate the slide while still holding the trigger. It functioned once or twice before it would do the same thing. I locked the slide back and looked in the action and there is a little tension spring attached to a hole but loose and flailing around in the mag well.
Turns out the little flailing spring was the one that puts upward tension on the trigger transfer bar. There isn't anything but a slight notch in the bottom of the transfer bar to hold it in place.
Anyone else have any experience with this problem?
Turns out the little flailing spring was the one that puts upward tension on the trigger transfer bar. There isn't anything but a slight notch in the bottom of the transfer bar to hold it in place.
Anyone else have any experience with this problem?
0
-
Wow, don't see much online but I found a google cached forum post on the Sig forum where some other folks had the same problem.
Apparently the piece I'm talking about is the trigger bar spring, and since the omega trigger systems short introduction its well known for problems. The magazine can catch or jar the spring out of position when being inserted. Which I didn't think about since I'm used to slamming mags into the well, just habit to assure firm seating.
I'm calling CZ customer service tomorrow. Hopefully they will install the original trigger system parts without charging me. The omega trigger wasn't all that great anyway. My well used CZ P01 has a way better trigger anyway.0
Please sign in to leave a comment.
Comments
1 comment