Where to find OEM but plate for '64 Rem 700

30-cal

November 04, 2011 19:53

I have a Remington 700 long action, manufactured in January of 1964. It is all original except for the recoil pad. Where can I locate the correct period but plate for my rifle so I can put it back original?
Dave

0

• 

  Laredo Lefty

  November 04, 2011 23:13

  You can start with Numrich Arms- gun parts corp. Then maybe Jack First.

  0
• 

  dcs shooters

  November 05, 2011 09:06

  There are 66 listed on ebay, from new to older aluminum.

  0
• 

  oneoldsap

  November 05, 2011 11:08

  I have a pile of Remington butt plates . If you give me the length and width at widest point , I may have one for you . plastic or aluminum ?

  0
• 

  30-cal

  November 05, 2011 21:44

  oneold,
  I will pull off the aftermarket pad check measurements & determine if it is 2 or 4 hole and re-post.

  0
• 

  oneoldsap

  November 06, 2011 01:38

  Did the person that installed the pad , square the stock ? if they did a factory plate isn't going to fit .

  0
• 

  oneoldsap

  November 07, 2011 13:14

  30cal I know you sent me your measurements , I read the message this morning . I can't seem to recover that message and didn't write them down could you resend please ?

  0

Please sign in to leave a comment.