Remington 1100 410 bore

bumpkin44

August 29, 2011 08:40

I'm a little skeptical about the reliability of the 410 in an 1100. I'd like to get one from gunbroker but I'm not sure they are as good as the seller's say. Tight tolerances in the 410 might be an issue especially with reloads. Any advice or experience with 410's in the 1100?

Thanks,

0

• 

  tsr1965

  August 29, 2011 08:49

  They are about the only 410 semi-automatic, that you can find on the skeet range. I have not heard of any issues with them, that one doesn't have with the other gauges. Keep the port clean, and the o-ring tite, and you are good to go.
  
  Best

  0
• 

  11b6r

  August 29, 2011 11:56

  Have had one since 1993. Specifies 3" only. Have only shot factory loads. Never had a single FTF. Of course, shoot a round of sporting clays with one, may require adjustment of humility levels..........[:p]

  0
• 

  22hipower

  August 30, 2011 13:15

  The "adjustment to humility levels" applies to trying to shoot dove with them too. No problems in reliability with mine although I only use factory loads. There does seem to be a hole in the middle of the pattern which is about dove sized though. . . . .

  0

Please sign in to leave a comment.