Skip to main content
Help Center Community Shop

BLR Trigger

Comments

5 comments

  • 260
    if my memory is right, i have helped the pull weight on one of these before. with the factory set up you dont have a lot of room. i do remember that once you take it apart, you have to get the timing set right on the bolt and lever. it's been awhile. hope this helps... 260
    0
  • chuck
    I have a BLR in 308 took the bolt out of it to give it a good cleaning I WILL NEVER DO THAT AGAIN THEIR ARE ABOUT 3 GRERS THAT HAVE TO BE LINED UP AND DONT ASK BROWNING FOR HELP ALL THEY SAY IS SEND IT IN.
    0
  • Jim Rau
    I have no problem removing the bolts and getting the timing right when I put them back together. I have repaired several and removed the bolts to put them in the lathe to thread them for brakes. But I have never worked on their triggers before.
    0
  • gnprts
    Jim ... I disassembled a BLR and now it requires a small amount of pressure on the lever to fire.... Is this normal or where have I missed? Thanks ....
    0
  • blacarrow
    The BLR is a rifle only QUALIFIED, repeat QUALIFIED gunsmiths should work on. Better yet, do as Browning suggests and send it back for needed work.
    Prior to retirement, I was the Chief Firearms Technician at Browning R&D. I devised special pins to aid in correctly reassembling the BLR.
    They are easy to take apart, but VERY difficult to put back together properly.
    The trigger problem you have is one that you can blame on blood sucking lawyers (or is that LIARS?) Gun manufacturers are forced to elevate safety standards to such a degree that hard triggers are the result.
    Just as ammo makers reduce most loads so that they will not pose a hazard in older firearms, gun makers are forced to design them so that most (not all) idiots won't shoot their friends when playing with their fireams. Sorry, but that's the way it is.
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?