Marlin model 60 problem
I have a Marlin model 60 that will chamber and fire the 1st round, eject the case and close the chamber. When you pull the trigger to fire the next round, it will not fire, only click. When you pull back the bolt, the shell is not chambered, but is at an angle with only the first third of the shell inside the chamber and 2 large dents on the side of the shell. What could be causing the 2nd round not to chamber? Thanks.
0
-
Give it a really good cleaning - including cleaning as much of the mag tube and mag tube insert (the part that actually pushes down on the bullets) as you can.
Then clean it again.
And if you think it is clean, clean it one more time.
Then repeat the test.
Could be the feed spring is weak, or something is off on the lifters, but so many of these fine little guns are so dirty a good cleaning will take care of most issues.0 -
What is the round count? As kids, my buddy, his brother and I could wear one out to jam-o-matic in the summer. The replacement would last over the winter and spring.
Inspect the magazine tube liner for dents. Use your cleaning rod to push the follower back inside the tube. Feel for tight spots or dragging zones. Could be a weak spring from left for years with a full magazine or dried crud build up on the inside.
Everyone of the 6 we wore out was at least a good shooter right up until it became a jam-o-matic.0 -
the feed throat needs to be replaced 0 -
tip of ejector is broken 0 -
+1. The housing is made from a zinc alloy ("pot metal"), chrome plated - when the plating wears through, they mis-feed. 0
Please sign in to leave a comment.
Comments
5 comments