Marlin 39A cartridge cuttoff spacer ?

Uintah

August 19, 2013 08:35

Does anyone know if a 1976 vintage Marlin 39A Golden would have the seperate cartridge cuttoff spacer? Marlin cannot tell me for tht age and the new ones do not have that part. I suspect from viewing a 1972 parts diagram for the 39A, which shows the cartridge cuttoff spacer as a seperate part, that 1976 would be the same. I have had feeding issues and upon dissassembly discovered only the cartridge cuttoff in place, with no spacer. Numerich is currently out of stock and Marlin considers that vintage obsolete and does not have any parts. If you have any other locations for one, please let me know. Thanks

0

• 

  charliemeyer007

  August 19, 2013 09:45

  The last 39A I work over years ago for feeding issues had the separate spacer. I tweaked the cutoff to make it work correctly.
  
  http://www.gunpartscorp.com/Manufacturers/MarlinGlenfield-33379/Rifles-37333/39Series-38980/39AEarlyModel-34037.htm

  0
• 

  Geri

  August 20, 2013 11:38

  Try JACK FISRT,INC 1201 turbine drive Rapid Cit, SD 57703 605-343-9544

  0
• 

  toad67

  August 20, 2013 15:11

  http://wisnersinc.com/rifles/marlin/rflever.htm

  0
• 

  Emmett Dunham

  August 20, 2013 15:32

  I have an older model 39 and the cut off has spring tennsion and it springs back every time a bullet passes to catch the next so the receiver does not get flooded with shells. I just took a small screw diver and pulled the stop up and it cured this problem and it has been quite a while since I did that. I would get the right screw driver and take stop out of the receivr (soak it in Kroil first) and clean the area behind the cut off and see if you can get it working by putting tension on the stop again. If that does not work buy a new one.

  0

Please sign in to leave a comment.