Ruger 3 screw original trigger parts
I was wondering if someone was able to find the original parts for a ruger 3 screw trigger mechanism what would one need. I have a converted super single six .22 (transfer bar) that doesn't have the original parts included before the factory conversation. If an individual was to use the factory parts list included in the owners manual which ones specifically would a person need to bring it back to its original condition. I might have access to the necessary parts but I need to know if I not only have the right ones but all of them as well. Would it be a concern as far as "fit goes if they didn't come out of the original gun to begin with.
0
-
My dad had a 3-screw 22 that wasn't changed. In thinking about the mechanism it seems to me that virtually the whole works would need to be replaced. The loading gate is different, as are the trigger and hammer. The parts that remained the same would likely be small & incidental; so I'd guess you will need to get the entire parts package and the parts that are duplicated will likely be very few. Due to this, there shouldn't be a problem with fitting old/new parts. 0 -
You can sometimes find the parts sets along with pictures and instructions on auction sites such as GunBroker. They are getting expensive, though. 0 -
Worst case you could go to www.stevespages.com and download both schematics and compare the two as to what parts they do and do not share. 0 -
Parts kits for Ruger 3 screw models start about $75.00 and can and do go up from there.
XXXXXX0
Please sign in to leave a comment.
Comments
4 comments