Reloading 308 and 30-06 Ammunition

Ivan9686

March 26, 2013 08:04

I am preparing to reload the subject ammunition and discovered that the 130 and 168 grain TSX 308 bullets I have slide into the commercial once fired brass from Weatherby Vanguards. I have reloaded 45-70 ammunition extensively using TSX bullets and have always found the used brass to be very snug fitting even before inserting into the die. Is this common and it will be corrected by the die or do I have a chamber issue with the two Weatherbys. Both have been fired less than 200 rounds and group sub MOA. Thanks for any input.

0

• 

  Laredo Lefty

  March 26, 2013 08:18

  Sounds like your "once fired brass" needs to be completely resized.

  0
• 

  charliemeyer007

  March 26, 2013 08:39

  Not unusual for un-sized cases to loosely fit bullets. Neck sized only should fix them.
  Sub MOA is good shooting for hunting guns using factory ammo.

  0
• 

  tsr1965

  March 26, 2013 09:05

  Your 45-70 operates at far less pressure, so the casings are not going to expand as much, as the 308 or 30-06. Your resizing die will take care of the non problem for you.
  
  I use the 130 grain TTSX(poly tipped), exclusively in my loads for the 308, and 30-06, for hunting everything, up to deer, and black bear.
  
  Best

  0
• 

  Ivan9686

  March 27, 2013 05:35

  thanks for putting my mind at ease.

  0
• 

  Hawk Carse

  March 27, 2013 06:01

  Bullets are SUPPOSED to slip fit into a FIRED case neck.
  If they are tight, it shows you have an undersize chamber which is not good.
  Maybe your .45-70 is just not expanding fully like tsr says.

  0

Please sign in to leave a comment.