Drilling tempered glass

bigbill0910

November 25, 2012 00:54

Tempered glass can not be altered. The annealed glass is cut and fabricated (drilled, notched, an such) before it is tempered in a high degree oven. After tempering it is in that state forever. No drill or water jet at all will do it.

0

• 

  11b6r

  November 25, 2012 01:29

  Have to agree with bigbill. Glass is "tempered" by being rapidly heated until the outer (but not inner) layer is just beginning to melt- and quickly chilled under a blast of cold air. This puts the sheet under tension. Any crack results in the tension breaking the entire sheet into small, non-jagged bits. Glass is cut, shaped, drilled, etc, PRIOR to being tempered. Any attempt to alter it usually results in a trashcan full of glass bits.

  0
• 

  BGHillbilly

  November 25, 2012 12:30

  Once tempered then that's it for modification. I know when we designed glass shelf store fixtures, we made sure all changes were made before ordering the temperd glass. Once we had the glass tempered that was it, use as it was or scrap it.

  0
• 

  EhlerDave

  November 25, 2012 18:53

  Well you fellas know this is going to toss a kink into my plans. [:)]
  
  Thanks for the info.

  0
• 

  sharpshooter039

  November 25, 2012 19:54

  I am going to have to disagree. I have seen holes drilled in tempered a few times, Mostly tempered glass aquariums. you stand a 50/50 chance of doing it without breakage. You need a Diamond Glass bit and you MUST keep it lubed while drilling and go very very slow,,Google it.

  0
• 

  EhlerDave

  November 25, 2012 20:02

  Well now I am just going to have to give it a try and see what happens. If I take care to keep it out of my eyes, all that can happen is busting a peice of glass.
  
  Not like I am scared to try things just because they should not be done. [:)]

  0
• 

  Horse Plains Drifter

  November 26, 2012 05:28

  So can one anneal the glass, work on it, then re-harden it like you can steel?

  0
• 

  yoshmyster

  November 26, 2012 10:25

  quote:Originally posted by Horse Plains Drifter
  So can one anneal the glass, work on it, then re-harden it like you can steel?
  
  
  Still waiting for someone to do the "Star Trek: Voyage Home" make clear aluminum sheets.
  
  As for the display case, just grind a corner off on a water wheel. Enough to pass a wire through.

  0
• 

  charliemeyer007

  November 26, 2012 10:29

  Go hi tech power it wirelessly. No holes required, and I still think a nanoplused laser would do it.

  0

Please sign in to leave a comment.