Update, firing pin extension

onepopper

November 24, 2012 04:38

This is what I have learned. Seems like the bolt can be assembled 2 ways, right and wrong. The wrong way allows the firing pin to protrude much further than normal. However, if assembled this wrong way, the safety is immoble. There is your indicator that something is wrong. Assembled correctly, the safety works as advertised. I fired the little carbine with reduced loads of cast lead paper patched bullets without a hitch. Firing pin depressions are normal. Again, thank you all for your inputs.

0

• 

  charliemeyer007

  November 24, 2012 05:29

  Thanks for the update on the bolt. Did you get anything on the bbl loose spot?

  0
• 

  rufe-snow

  November 24, 2012 05:48

  When you received it from CZ as a replacement for the previous one(s) with the bad barrels, was the bolt assembled correctly?

  0
• 

  onepopper

  November 24, 2012 17:31

  I sent a letter to the factory in Czechoslovakia explaining the problem in detail along with the three serial numbers. I recieved no answer.
  
  The carbine came properly assembled from the distributor. It was I that improperly reassembled the bolt during cleaning.
  
  Thanks again for your interest.

  0

Please sign in to leave a comment.