H&R sear spring needed
Does anyone know of a parts supply Company that would have a H&R
model 1904 sear spring Coil compression spring about 1/32 in diameter and 1/8 inch long Try a number of places but all list but out of stock
[:(][:(]
model 1904 sear spring Coil compression spring about 1/32 in diameter and 1/8 inch long Try a number of places but all list but out of stock
[:(][:(]
0
-
Call Bob and check with him yet?
http://www.gun-parts.com/harringtonrichardson/
If you have the old spring, Wolff might make one up for you. If all else fails, send it to me, I should have something here that'll work.0 -
http://www.brownells.com/search/index.htm?k=coil+spring+kit&ksubmit=y
I have two of their old kits that came in clear plastic tubes, somewhere in my collection.0 -
You have an e-mail coming about this subject. 0 -
Thanks All . I think I have found a local source for some springs and hope I can find one that will work. Karl. 0 -
SUCCESS Well went to an office machine repair shop Guy let me look through some junked machines got three different sizes in both strength
and diameter X length what a PIA as had to make a number of slave pins
To hold parts in place while doing assembly of all the parts. surprisingly the single action trigger pull is sort of heavier than it
needs to be but now gun works both Single action and double action and
hammer also latches back at loading notch. Before it would only fire double action and there was no latching the hammer in any position it was always fully forward with firing pin sticking out of the recoil shield of the frame . I am glad I never worked at H&R putting these things together.
you need 5 hands and slave pins to hold every thing in place.0 -
Good work Perry. I often scrap out broken stuff I find folks throwing away just for the little parts. 0
Please sign in to leave a comment.
Comments
6 comments